Thermal Shock Test Chamber Manufacturers

1. Heat preservation envelop enclosure:

•      Outer wall material: cold-roll steel sheet stoving varnish.
•      Inwall material:  stainless steel plate SUS304.
•      Body heat preservation material: rigid polyurethane foam and glass fiber.
•      Door heat preservation material:  glass fiber.

2. Air conditioning channel: Fan, heater, evaporator, air door and temperature sensor.
3. The standard configuration of chamber body: a lead drilling hole, locate on the left surface of the chamber body, φ50mm round hole.

4. load capacity of test chamber basket (uniform distribution),

    2 sample basket, 5kg load capacity each(uniform distribution).

5. Adjusting foot and adjusting wheel: 4 adjusting feet to support the test chamber, 4 adjusting wheels to move the test chamber.
6. Thermal shock test chamber door: single open, left hinge, right handle (reference of Test chamber outline drawing).
7. Circulating fan:  

•  High temperature/ring temperature exposure:  3φ,400W, centrifugal
•  Low temperature exposure:  3φ,400W, centrifugal

8. Control panel: Controller display screen, failure indicator, hour meter, R232 interface and over temperature protection setting device, total power switch.

9. Thermal shock test machine room: Refrigeration unit, drainage device, exhaust fan.

10. Power distribution control cabinet: main power leakage circuit breaker, controller, power distribution board, cooling fan, high and low temperature circle back fan motor.

11. Heater: Nickel chromium alloy strip heater,
      Heater control mode: non-contacting periodic pulse width, SSR (solid-state relay).
12. Power line hole and drain hole: at the back of the thermal shock chamber.